BACK DOOR > ADJUSTMENT |
| 1. INSPECT BACK DOOR |
Check that the clearance of areas A to P are within the standard range.

| Area | Measurement | Area | Measurement |
| A | 21.4 mm (0.843 in.) | I | 21.5 mm (0.847in.) |
| B | 5.2 mm (0.205 in.) | J | 5.2mm (0.205in.) |
| C | 10.1 mm (0.398 in.) | K | 10.4 mm (0.409in.) |
| D | 110.9 mm (4.366 in.) | L | 111 mm (4.37in.) |
| E | 20 mm (0.787 in.) | M | 18 mm (0.709in.) |
| F | 5.2 mm (0.205 in.) | N | 5.2 mm (0.205in.) |
| G | 10.2 mm (0.402 in.) | O | 10.4 mm (0.409in.) |
| H | 110.9 mm (4.366in.) | P | 111 mm (4.37in.) |
| 2. ADJUST BACK DOOR |
Disconnect the cable from negative (-) battery terminal from the battery.
![]() |
Loosen the bolts to adjust the back door upper up and down, side to side.
When adjusting the back door rear side to side, and the back door lock striker assembly, loosen the bolts until the striker can move. Lightly tap the striker with a brass bar for adjustment.

After completing fitting adjustment, confirm the position of the back door side female stopper and back door side male stopper.

Connect the negative (-) terminal cable to the battery.
Initialize both systems.
Inspect the SRS warning light.