Home › ENGINE ยท 2KD-FTV › FUEL › FUEL FILTER

FUEL FILTER > INSTALLATION

for Preparation Click here



1. INSTALL FUEL FILTER ELEMENT


    A102693E01
  1. Attach 2 new O-ring to a new fuel filter element sub-assembly and a new O-ring to the fuel filter case sub-assembly.

  1. Install the fuel filter element sub-assembly to fuel filter case sub-assembly.



    A102984
  1. Align the matchmark on fuel filter cap assembly with the 2 matchmarks on the fuel filter case sub-assembly.



    A102985E01
  1. Turn the fastener nut until a 'click' sound is heard.

    HINT:
    Just before the marks of the case and nut align, the turning difficulty of the fastener nut will increase. Use a screwdriver as a lever to turn the fastener nut.

  1. Install the fuel filter assembly.

  1. Install the 2 fuel hoses.

  1. Install the 2 fuel heater hoses. (w/ fuel heater)



2. INSTALL FUEL TANK CAP ASSEMBLY


3. CONNECT BATTERY NEGATIVE CABLE


4. RESET FUEL FILTER AND FILTER WARNING LAMP
  1. Turn the ignition switch on.



    A103400E01
  1. After turning the ignition switch on, connect the clogging sensor connector within 3 to 60 seconds.

  1. Check that the combination meter's filter warning light turns off.



5. BLEED FUEL LINE


    A114068E01
  1. Using the hand pump, bleed air from the fuel system until pumping becomes difficult.



6. PREFORM INITIALIZATION
(Click here)


7. CHECK FOR FUEL LEAKS
  1. PERFORM ACTIVE TEST

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Powertrain / ECD / Active Test.

    5. Perform the Active Test.

      Intelligent Tester Display
      Test Details
      Control Range
      Diagnostic Notes
      Test the Fuel Leak
      Pressurizes common rail internal fuel pressure, and checks for fuel leaks
      Stop/Start
      1. Fuel pressure inside common rail pressurized to specified value and engine speed increased to 2,000 rpm when ON is selected
      2. Above conditions preserved while test is ON