FUEL FILTER > INSTALLATION |
| 1. INSTALL FUEL FILTER ELEMENT SUB-ASSEMBLY |
![]() |
Attach 2 new O-rings to a new fuel filter element sub-assembly and a new O-ring to the fuel filter case sub-assembly.
Install the fuel filter element sub-assembly to the fuel filter case sub-assembly.
![]() |
Align the matchmark on the fuel filter cap assembly with the 2 matchmarks on the fuel filter case sub-assembly
![]() |
Turn the fastener nut until a 'click' sound is heard.
Install the fuel filter assembly.
Install the 2 fuel hoses.
Install the 2 fuel heater hoses.
| 2. INSTALL FUEL TANK CAP ASSEMBLY |
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 4. RESET FUEL FILTER AND FILTER WARNING LAMP |
Turn the ignition switch on.
![]() |
After turning the ignition switch on, connect the clogging sensor connector within 3 to 60 seconds.
Check that the combination meter's filter warning light turns off.
| 5. BLEED AIR FROM FUEL SYSTEM |
![]() |
Using the hand pump, bleed air from the fuel system until pumping becomes difficult.
| 6. PERFORM INITIALIZATION |
| 7. CHECK FOR FUEL LEAKS |
Check that there are no fuel leaks anywhere on the fuel system after doing maintenance.