Home › ENGINE ยท 5L-E › FUEL › FUEL FILTER

FUEL FILTER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. LOOSEN FUEL TANK CAP ASSEMBLY


3. REMOVE FUEL FILTER ELEMENT SUB-ASSEMBLY


    A102980J02
  1. Disconnect the vacuum switch connector and warning switch connector.

  1. Disconnect the 2 fuel hoses.

  1. Disconnect the 2 fuel heater hoses. (w/ fuel heater)

  1. Loosen the drain cock to drain fuel.

  1. Tighten the drain cock.



    A102981
  1. Using a screwdriver, loosen the fastener nut until the can be loosened by hand.



    A102982
  1. Fully loosen the fastener nut by hand.

    HINT:
    Loosen the fastener until the fuel filter cap assembly is removed.



    A102983
  1. Remove the fuel filter cap assembly, pull up one side of the fuel filter cap assembly and then lift off, as shown in the illustration.

  1. Remove the fuel filter element sub-assembly from the fuel filter case sub-assembly.

  1. Remove the O-rings from the fuel filter case sub-assembly.