Home › ENGINE ยท 2TR-FE › FUEL › FUEL PUMP

FUEL PUMP > INSTALLATION

for Preparation Click here



1. INSTALL FUEL PUMP ASSEMBLY


    A102702E01
  1. Install the fuel pump assembly and fuel bent tube set plat with the 8 bolts.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }



2. CONNECT FUEL TANK WIRE CONNECTOR


    A102481E01
  1. Connect the fuel tank wire connector to the fuel pump assembly.



3. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY


    A102480E01
  1. connect the fuel tank main tube with the tube joint clip.



4. CONNECT FUEL TANK RETURN TUBE


    A102479E01
  1. Connect the fuel tank return tube with the tube joint clip.



5. CONNECT FUEL TANK EVAPORATION TUBE SUB-ASSEMBLY NO.1


    A102478E01
  1. Match the axis of the connector with the axis of the pipe, and push into the connector until the connector makes a 'click' sound. In case that the connection is tight, apply a small amount of fresh engine oil to the tip of the pipe.

    NOTICE:
    1. Check that there is any damage or foreign objects in the connected part of the pipe.
    2. After finishing the connection, check if the pipe and the connector are securely connected by pulling them.



6. INSTALL FUEL SERVICE HOLE COVER
  1. Install the fuel service hole cover with the 4 screws.



7. CONNECT BATTERY NEGATIVE CABLE


8. CHECK FOR FUEL LEAKS
  1. When using the intelligent tester

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to the on position and intelligent tester main switch ON.

      NOTICE:
      Do not start the engine.

    3. Select the Active Test mode on the intelligent tester.

      HINT:
      Please refer to the intelligent tester operator's manual for further details.



  1. When not using the intelligent tester.



      A103380E01
    1. Disconnect the fuel pump connector.

    2. Using a service wire, connect terminals FP and +B of the relay block.

      NOTICE:
      Pay attention to the terminal connecting position to avoid a malfunction.

    3. Turn the ignition switch to the ON position, and check that the fuel pump operates.

      NOTICE:
      Do not start the engine.

  1. Check that there are no fuel leaks anywhere on the fuel system after doing maintenance.

  1. Check that the pulsation damper screw rises up when the fuel pump operates.
    If operation is not as specified, check the following parts:

    1. Fusible link
    2. Fuel pump
    3. Wiring connections
    4. ECM
    5. Fuses

  1. Turn the ignition switch off.

  1. Disconnect the intelligent tester from the DLC3.