Home › ENGINE ยท 2TR-FE › FUEL › FUEL PUMP

FUEL PUMP > REMOVAL

for Preparation Click here



1. DISCHARGE FUEL SYSTEM PRESSURE
  1. When using the intelligent tester

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to the on position and intelligent tester main switch ON.

      NOTICE:
      Do not start the engine.

    3. Select the Active Test mode on the intelligent tester.

      HINT:
      Please refer to the intelligent tester operator's manual for further details.



  1. When not using the intelligent tester.



      A103380E01
    1. Disconnect the fuel pump connector.

    2. Using a service wire, connect terminals FP and +B of the relay block.

      NOTICE:
      Pay attention to the terminal connecting position to avoid a malfunction.

    3. Turn the ignition switch to the ON position, and check that the fuel pump operates.

      NOTICE:
      Do not start the engine.

  1. Check that there are no fuel leaks anywhere on the fuel system after doing maintenance.

  1. Check that the pulsation damper screw rises up when the fuel pump operates.
    If operation is not as specified, check the following parts:

    1. Fusible link
    2. Fuel pump
    3. Wiring connections
    4. ECM
    5. Fuses

  1. Turn the ignition switch off.

  1. Disconnect the intelligent tester from the DLC3.



2. SEPARATE BATTERY NEGATIVE CABLE


3. REMOVE FUEL SERVICE HOLE COVER
  1. Remove the 4 screws and fuel service hole cover.



4. DISCONNECT FUEL EVAPORATION TUBE SUB-ASSEMBLY


    A102478E01
  1. Disconnect the fuel evaporation tube sub-assembly. (Click here)



5. DISCONNECT FUEL TANK RETURN TUBE


    A102479E01
  1. Remove the tube joint clip, disconnect the fuel tank return tube.



6. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY


    A102480E01
  1. Remove the tube joint clip, disconnect the fuel tank main tube sub-assembly.



7. DISCONNECT FUEL TANK WIRE CONNECTOR


    A102481E01
  1. Disconnect the fuel tank wire connector from the fuel pump assembly.



8. REMOVE FUEL PUMP ASSEMBLY


    A102702E01
  1. Remove the 8 bolts, fuel bent tube set plat and fuel pump assembly from the fuel tank assembly.