EXHAUST PIPE (for Long Wheelbase) > INSTALLATION |
| 1. INSTALL EXHAUST PIPE ASSEMBLY TAIL |
Connect the exhaust pipe supports, and install the exhaust pipe assembly tail.
| 2. INSTALL EXHAUST PIPE SUB-ASSEMBLY FRONT NO.1 |
Install a new gasket and exhaust pipe sub-assembly front No.1 with the 3 bolts.
Tighten the clamp bolt, and install the exhaust pipe support bracket No.1 to the exhaust pipe sub-assembly front No.1.
| 3. INSTALL EXHAUST PIPE SUB-ASSEMBLY FRONT NO.2 |
![]() |
Inspect the compression spring.
Using vernier calipers, measure the free length of the compression springs.
![]() |
Install the gasket.
Fully insert a new gasket to the exhaust pipe sub-assembly front No.1 by hand.
Using a wooden block, uniformly strike the gasket so that the gasket and exhaust pipe sub-assembly front No.1 are properly fit.
Connect the exhaust pipe support, and install a new gasket and the exhaust pipe sub-assembly front No.2 with the 4 bolts, 2 nuts, and 2 compression springs.
| 4. CHECK FOR EXHAUST GAS LEAKS |