Home › ENGINE ยท 5L-E › COOLING › SUB RADIATOR

SUB RADIATOR > INSTALLATION

for Preparation Click here



1. INSTALL SUB RADIATOR ASSEMBLY


    A102449E02
  1. Install the sub radiator assembly with the bolts.

    Torque:
    20 N*m{ 200 kgf*cm , 14 ft.*lbf }

  1. Connect the fan connector.



    A102448E07
  1. Connect the upper and lower hose to the radiator assembly.



2. INSTALL FAN SHROUD NO.2
  1. Install the bolt and fan shroud No.2.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }



3. INSTALL HIGH PITCHED HORN ASSEMBLY


4. INSTALL WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY


5. INSTALL RADIATOR RESERVE TANK ASSEMBLY


6. INSTALL RADIATOR SUPPORT UPPER


7. INSTALL HOOD LOCK ASSEMBLY


8. INSTALL FRONT BUMPER REINFORCEMENT


9. INSTALL HOOD LOCK SUPPORT BRACE SUB-ASSEMBLY


10. INSTALL AIR INLET DUCT NO.1


11. INSTALL FRONT BUMPER


12. INSTALL STEP PLATE COVER RH


13. INSTALL STEP PLATE COVER LH


14. INSTALL RADIATOR GRILLE


15. ADD ENGINE COOLANT
  1. Close the engine drain plug.

    Torque:
    57 N*m{ 581 kgf*cm , 42 ft.*lbf }

  1. Close the radiator drain cock plug.

  1. Slowly fill the cooling system with coolant.

    HINT:
    The coolant level inside the radiator should be abserved after pressing the radiator hose inlet and radiator hose outlet by hand..

  1. Slowly pour coolant into the radiator reserve tank until it reaches the FULL line.

  1. Install the radiator cap to the radiator reserve tank.

  1. Press the inlet and outlet radiator hoses several times by hand while warming up the engine.

  1. Stop the engine, and wait until the engine coolant cools down.

  1. Add coolant to the FULL line of the radiator reservoir.



16. START THE ENGINE


17. CHECK FOR ENGINE COOLANT LEAKS