Home › ENGINE ยท 5L-E › COOLING › SUB RADIATOR

SUB RADIATOR > REMOVAL

for Preparation Click here



1. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



  1. Loosen the radiator drain cock plug and engine drain plug, then drain the coolant.


    A114683E02

  1. Remove the radiator cap.



2. REMOVE RADIATOR GRILLE


    B101611E01
  1. Remove the 2 clips and 2 screws.

  1. Release the 6 claws and 4 clips and remove the radiator grille.



3. REMOVE AIR INLET DUCT NO.1


    A106855E01
  1. Remove the 3 clips and the air inlet duct No.2.

  1. Remove the 2 bolts, 2 clips and the air inlet duct No.1.



4. REMOVE STEP PLATE COVER LH


5. REMOVE STEP PLATE COVER RH

HINT:
Use the same procedures as for the LH side.



6. REMOVE FRONT BUMPER


    E109046E01
  1. Remove the 8 clips and 3 bolts.

  1. Release the 12 claws and remove the bumper.

  1. Disconnect the connectors. (w/ fog light)



7. REMOVE HOOD LOCK SUPPORT BRACE SUB-ASSEMBLY


8. REMOVE FRONT BUMPER REINFORCEMENT


9. REMOVE HOOD LOCK ASSEMBLY


10. REMOVE RADIATOR SUPPORT UPPER


11. REMOVE RADIATOR RESERVE TANK ASSEMBLY


12. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY


13. REMOVE HIGH PITCHED HORN ASSEMBLY


14. REMOVE FAN SHROUD NO.2
  1. Remove the bolt and fan shroud No.2.



15. REMOVE SUB RADIATOR ASSEMBLY


    A102448E04
  1. Disconnect the water hose from the radiator assembly.

  1. Disconnect the sub radiator assembly lower hose



    A102449E01
  1. Disconnect the connector from the sub radiator fan motor.

  1. Remove the bolts and sub radiator assembly.