Home › ENGINE ยท 5L-E › COOLING › RADIATOR

RADIATOR > REMOVAL

for Preparation Click here



1. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



  1. Loosen the radiator drain cock plug and engine drain plug, then drain the coolant.


    A114683E02

  1. Remove the radiator cap.



2. DRAIN HFC-134A (R134A)


3. REMOVE RADIATOR GRILLE


    B101611E01
  1. Remove the 2 clips and 2 screws.

  1. Release the 6 claws and 4 clips and remove the radiator grille.



4. REMOVE AIR INLET DUCT NO.1


    A106855E01
  1. Remove the 3 clips and the air inlet duct No.2.

  1. Remove the 2 bolts, 2 clips and the air inlet duct No.1.



5. REMOVE RADIATOR RESERVE TANK ASSEMBLY
  1. Remove the bolt and radiator reserve tank assembly.



6. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
  1. Remove the 2 bolts and windshield washer motor and pump assembly



7. REMOVE STEP PLATE COVER LH


8. REMOVE STEP PLATE COVER RH

HINT:
Use the same procedures as for the LH side.



9. REMOVE FRONT BUMPER


    E109046E01
  1. Remove the 8 clips and 3 bolts.

  1. Release the 12 claws and remove the bumper.

  1. Disconnect the connectors. (w/ fog light)



10. REMOVE HOOD LOCK SUPPORT BRACE SUB-ASSEMBLY


11. REMOVE HOOD LOCK ASSEMBLY


    A102027E04
  1. Remove the 2 bolts and hood lock assembly.

  1. Remove the hood lock assembly from the hood lock control cable assembly.



12. REMOVE RADIATOR SUPPORT UPPER


    A103434E07
  1. Remove the 6 bolts and radiator support upper



13. REMOVE FRONT FLOOR CROSS MEMBER REINFORCEMENT SUB-ASSEMBLY RH


14. REMOVE FRONT BUMPER REINFORCEMENT


15. DISCONNECT COOLER REFRIGERANT DISCHARGE PIPE A


16. DISCONNECT COOLER REFRIGERANT LIQUID PIPE A


17. REMOVE W/RECEIVER CONDENSER ASSEMBLY


18. REMOVE COOLING FAN ECU
  1. Disconnect the 4 connectors from the cooling fan ECU.



    A116095
  1. Remove the 2 bolts, 2 nuts, and cooling fan ECU.



19. REMOVE FAN SHROUD


    A116096
  1. Remove the 6 bolts. Remove the fan shroud from the underside of the vehicle

    NOTICE:
    Disconnect the radiator hose No.3 and radiator hose inlet.



20. REMOVE FAN SHROUD NO.2


    A102971E04
  1. Remove the 2 bolts. Remove the fan shroud No.2 from the underside of the vehicle.

    HINT:
    Do not damage the radiator assembly when removing the fan shroud No.2.



21. REMOVE RADIATOR ASSEMBLY


    A102446
  1. Remove the radiator assembly.