Home › ENGINE ยท 2TR-FE › COOLING › THERMOSTAT

THERMOSTAT > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER NO.1


2. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Remove the radiator cap.



  1. Loosen the radiator drain plug and a cylinder block drain plug. Then drain the coolant.


    A115990E01



3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


4. REMOVE FRONT SEAT ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



5. REMOVE FRONT SEAT ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



6. REMOVE FRONT DOOR SCUFF PLATE RH


7. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY
  1. Roll up the carpet, and remove the 5 bolts and engine service hole sub cover.



8. REMOVE FAN AND GENERATOR V BELT


    A102135E01
  1. Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and decrease the tension in the drive belt. Then remove the drive belt.

    NOTICE:
    When removing the drive belt, do not use the idle pulley's bolt.

    HINT:
    After removing the drive belt, move the tensioner upward to the maximum amount.



9. DISCONNECT VANE PUMP ASSEMBLY


    A102130E01
  1. Disconnect the PS fluid pressure switch connector.

  1. Remove the 2 bolts and disconnect the pump from the engine.

  1. Support the vane pump securely.



10. REMOVE WATER INLET


    A087301
  1. Remove the 2 nuts, bolt, water inlet and gasket.



11. REMOVE THERMOSTAT


    A086841J01
  1. Remove the thermostat.