GENERATOR > INSTALLATION |
| 1. INSTALL GENERATOR ASSEMBLY |
![]() |
Install the generator assembly with the 3 bolts.
Install the generator wire with the nut to terminal B.
Install the terminal cap.
Connect the generator connector.
| 2. INSTALL FAN AND GENERATOR V BELT |
![]() |
Install the drive belt to the pulleys except the drive belt tensioner pulley.
Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and then install the drive belt to the tensioner pulley.
![]() |
After a new belt has been installed, check that the tensioner indicator mark is within range A shown in the illustration.
| 3. INSTALL ENGINE SERVICE HOLE SUB COVER ASSEMBLY |
Install the engine service hole sub cover with the 5 bolts.
| 4. INSTALL FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type) |
| 5. INSTALL FRONT SEAT ASSEMBLY RH (for Low-back Seat Type) |
| 6. INSTALL FRONT DOOR SCUFF PLATE RH |
| 7. CONNECT NEGATIVE BATTERY CABLE |
| 8. INSTALL ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1) |
| 9. PERFORM INITIALIZATION |
Some system need initialization when reconnecting the battery cable. (Click here)