Home › ENGINE · 2TR-FE › FUEL › FUEL INJECTOR

FUEL INJECTOR > INSPECTION

for Preparation Click here



1. FUEL INJECTOR ASSEMBLY
  1. Inspect injector resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Resistance::
      11.6-12.4Ω at 20°C (68°F)

      HINT:
      If the resistance is not as specified, replace the injector.



    A087755E01
  1. Inspect injector.

    NOTICE:
    This test involves high-pressure fuel and electricity. Take all precautions regarding safe handling of both the fuel and the electricity. Perform this test in a safe area, and avoid any spark or flame. Do not smoke.

    SST
    09268-41048   (09268-41110, 09268-41091, 09268-41120, 09268-41310, 90467-13001, 95336-08070, 09268-41500)



      A088653E01
    1. Install the SST (tube connector) to SST (hose), then connect the fuel filter.

      SST
      09268-41048   (90467-13001, 95336-08070, 09268-41500)

    2. Remove the pressure regulator from the delivery pipe.

    3. Install the O-ring to the fuel inlet of the pressure regulator.



    4. A088655E01
    5. Connect SST (hose) to the fuel inlet of the pressure regulator with another SST (union) and the 2 bolts.

      SST
      09268-41048   (09268-41091, 90467-13001, 95336-08070)

      Torque:
      8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

    6. Install the O-ring to the injector.



    7. A086833E01
    8. Connect SSTs (adaptor and hose) to the injector, and hold the injector and union with SST (clamp).

      SST
      09268-41048   (09268-41110, 09268-41310, 90467-13001, 95336-08070)

    9. Put the injector into a graduated cylinder.

      HINT:
      Install a suitable vinyl tube onto the injector to prevent gasoline splashing.

    10. Operate the fuel pump



    11. A086834E01
    12. Connect SST (wire) to the injector and the battery for 15 seconds, and measure the injection volume with a graduated cylinder. Test each injector 2 or 3 times.

      SST
      09842-30080  

      Result:
      Volume
      Difference between each injector
      71 to 86ml
      15ml or less

      NOTICE:
      Be sure to switch at the battery terminal side.

      HINT:
      If the injection volume is not as specified, replace the injector.



  1. Check for leakage.



      A087750
    1. In the condition above, disconnect the tester probes of SST (wire) from the battery and check for fuel leakage from the injector.

      Fuel Drop:
      1 drop or less in 12 minutes