Home › ENGINE ยท 2TR-FE › EMISSION CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL OXYGEN SENSOR


  1. Install oxygen sensor (w/ secondary air injection system).



      A102380E01
    1. Using SST, install the oxygen sensor to the exhaust pipe assembly front.

      SST
      09224-00010  

      Torque:
      40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    2. Connect the oxygen sensor connector.



  1. Install oxygen sensor (w/o secondary air injection system).



      A102377E01
    1. Using SST, install the oxygen sensor to the exhaust pipe assembly front.

      SST
      09224-00010  

      Torque:
      40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    2. Connect the oxygen sensor connector.



2. REMOVE ENGINE UNDER COVER NO.2 (w/ Engine Under Cover No.2)
  1. Install the engine under cover No.2 together with the engine side under cover LH and engine side under cover RH (for Wide Body).

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }