Home › ENGINE · 2TR-FE › EMISSION CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > INSPECTION

for Preparation Click here



1. INSPECT OXYGEN SENSOR


  1. Inspect the sensor heater.



      A062067E02
    1. Measure the resistance between terminals 1 (HT) and 2 (+B) of the sensor.

      Standard resistance:
      11 to 16 Ω at 20°C (68°F)

      If the result is not as specified, replace the oxygen sensor.

    2. Measure the resistance between terminals 1 (HT) and 4 (E1) of the sensor.

      Standard resistance:
      10 kΩ or higher

      If the result is not as specified, replace the oxygen sensor.