Home › ENGINE ยท 2TR-FE › LUBRICATION › OIL FILTER

OIL FILTER > INSTALLATION

for Preparation Click here



1. INSTALL OIL FILTER SUB-ASSEMBLY


    G037462E01
  1. Check and clean the oil filter installation surface.

  1. Apply clean engine oil to the gasket of a new oil filter.

  1. Lightly screw the oil filter into place, and tighten it until the gasket contacts the seat.



    A099196
  1. Using SST, tighten the oil filter.

    SST
    09228-07501  

    When using a torque wrench:
    Tighten the oil filter.

    Torque:
    17 N*m{ 175 kgf*cm , 13 ft.*lbf }

    When not using a torque wrench:
    Tighten the oil filter an additional 3/4 turn.



2. ADD ENGINE OIL
  1. Add fresh engine oil.

    Standard capacity:
    Item
    Capacity
    Drain and refill with oil filter change
    5.5 liters (5.8 US qts, 4.8 lmp. qts)
    Drain and refill without oil filter change
    5.0 liters (5.3 US qts, 4.4 lmp. qts)
    Dry fill
    6.3 liters (6.7 US qts, 5.5 lmp. qts)

  1. Install the oil filler cap.



3. CHECK FOR ENGINE OIL LEAKS
  1. Start the engine. Check for engine oil leaks from the oil filter connection.



4. INSTALL ENGINE UNDER COVER NO.2 (for Narrow Body, w/ Engine Under Cover No.2)

Torque:
13 N*m{ 133 kgf*cm , 10 ft.*lbf }



5. INSTALL ENGINE SIDE UNDER COVER RH (for Wide Body, w/ Engine Side Under Cover RH)

Torque:
13 N*m{ 133 kgf*cm , 10 ft.*lbf }