Home › ENGINE · 2TR-FE › EMISSION CONTROL › AIR PUMP

AIR PUMP > INSPECTION

for Preparation Click here



1. INSPECT AIR PUMP ASSEMBLY


  1. Check the resistance.



      A102499
    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      0.4 to 1.0 Ω at 20°C (68°F)

      If the result is not as specified, replace the air pump.



  1. Check operation of the air pump.



      A099547E02
    1. Check that air does not flow from port A to port B.
      If the result is not as specified, replace the air pump.



    2. A099540
    3. Apply battery voltage across terminals 1 and 2.

    4. Check that air flows from port A to port B.
      If the result is not as specified, replace the air pump.

      NOTICE:
      1. Do not operate the air pump for 5 seconds or more.
      2. When operating the air pump continuously, wait until the pump is cooled down between each operation. If the pump has not cooled down sufficiently, the motor will burn out.