LOAD SENSING PROPORTIONING VALVE > DISASSEMBLY |
| 1. REMOVE LOAD SENSING PROPORTIONING VALVE ASSEMBLY |
![]() |
Place the load sensing valve in the vise.
Remove the nut while holding the bolt.
Remove the 2 nuts, the valve set plate and the valve bracket.
![]() |
Remove the clip and the load sensing proportioning valve assembly.
| 2. REMOVE LOAD SENSING SPRING BUSH & BOOT KIT |
![]() |
Place the load sensing spring bracket in the vise.
Remove the bolt, load sensing spring bracket, collar and the 2 bushs from the spring shackle No.2.
![]() |
Remove the 2 plate washers, spring washer, spring shackle No.1, bolt, and nut.
![]() |
Remove the lock nut, spring shackle No.1, plate washer, and nut from the spring shackle No.2.
![]() |
Remove the following parts from the load sensing spring.
| Symbol | Name | Quantity |
| A | Load sensing spring bush No.1 | 2 |
| B | Load sensing spring bush No.2 | 2 |
| C | Load sensing spring collar | 1 |
| D | Load sensing valve boot | 1 |
| E | Load sensing spring boot | 1 |
| F | Load sensing spring washer | 2 |
| G | Load sensing spring collar | 1 |