LOAD SENSING PROPORTIONING VALVE > REASSEMBLY |
| 1. INSTALL LOAD SENSING SPRING BUSH & BOOT KIT |
![]() |
Apply lithium soap base glycol grease to the parts shown in the illustration.
![]() |
Install a new valve boot and a new spring boot to the spring assembly.
Install a new load sensing spring bush No.1, No.2, collar and the plate washer to the valve boot.
![]() |
Install the spring shackle No.1, plate washer, nut and the lock nut to the spring shackle No.2.
![]() |
Place the spring shackle in the vise.
With the 2 plate washers on both sides of the load sensing spring boot, insert the bolt through the washers, spring shackle No.1, and spring boot.
Tighten the nut while holding the bolt.
![]() |
Install the 2 shackle bushes and the collar to the spring shackle No.2.
Install the bolt and spring shackle No.2 to the load sensing spring bracket.
![]() |
Turn the nut and lock nut so that dimension A, shown in the illustration, is adjusted to approximately 120 mm (4.724 in.).
| 2. INSTALL LOAD SENSING PROPORTIONING VALVE ASSEMBLY |
![]() |
Install the valve boot to the load sensing proportioning valve assembly.
![]() |
Place the load sensing proportioning valve assembly in the vise.
Install the load sensing spring assembly to the load sensing valve boot with the 2 washers, bolt, and nut.
Install the valve bracket with the 2 spring washers, valve set plate, and 2 nuts.