THERMOSTAT > INSTALLATION |
| 1. INSTALL THERMOSTAT |
Install a new gasket on the thermostat.
Install the thermostat with the jiggle valve upward.
| 2. INSTALL RADIATOR HOSE NO.4 |
Install the water outlet and the radiator inlet hose with the 3 bolts.
| 3. INSTALL RADIATOR HOSE INLET |
| 4. INSTALL ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY |
Install the 5 bolts and engine service hole cover.
| 5. INSTALL FRONT DOOR SCUFF PLATE RH |
| 6. INSTALL FRONT SEAT RH |
![]() |
Connect the front seat inner belt assembly connector and install the front seat assembly.
Align the front seat assembly adjuster pin with the holes in the body.
Move the front seat assembly to the rearmost position.
Temporarily tighten the 2 bolts on the front side of the front seat assembly.
Move the front seat assembly fully forward.
Temporarily tighten the 2 bolts on the rear side of the front seat assembly.
Move the front seat assembly to the rearmost position.
Fully tighten the 2 bolts on the front side of the front seat assembly in the order of outer and inner side.
Move the front seat assembly fully forward.
Fully tighten the 2 bolts on the rear side of the front seat assembly in the order of outer and inner side.
| 7. ADD ENGINE COOLANT |
Close the engine drain plug.
Close the radiator drain cock plug.
Slowly fill the cooling system with coolant.
Slowly pour coolant into the radiator reserve tank until it reaches the FULL line.
Install the radiator cap to the radiator reserve tank.
Press the inlet and outlet radiator hoses several times by hand while warming up the engine.
Stop the engine, and wait until the engine coolant cools down.
Add coolant to the FULL line of the radiator reservoir.
| 8. START THE ENGINE |
| 9. CHECK FOR ENGINE COOLANT LEAKS |