Home › ENGINE ยท 2KD-FTV › COOLING › THERMOSTAT

THERMOSTAT > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER NO.1


2. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Remove the radiator cap.



  1. Loosen the radiator drain cock plug and a cylinder block drain cock plug. Then drain the coolant.


    A103477E01



3. DISCONNECT BATTERY NEGATIVE CABLE


4. REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)

HINT:
Perform the same procedure as RH side on the LH side.



5. REMOVE FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)

HINT:
Perform the same procedure as RH side on the LH side.



6. REMOVE FRONT DOOR SCUFF PLATE RH


7. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY
  1. Roll up the carpet, and remove the engine service hole sub cover assembly.



8. REMOVE FENDER APRON MUDGUARD SEAL RH


9. REMOVE FAN AND GENERATOR V BELT


    A102808E03
  1. Remove the drive belt by rotating the tensioner pulley in clockwise direction to loosen its tension with the pulley set bolt of the tensioner.



10. SEPARATE COMPRESSOR AND MAGNETIC CLUTCH (w/ Air Conditioning)
  1. Disconnect the connector.



    E104245
  1. Remove the 4 bolts and compressor and magnetic clutch.



11. REMOVE AIR TUBE ASSEMBLY
  1. Remove the 2 clamps, 2 bolts and air tube assembly.



12. REMOVE AIR CLEANER HOSE ASSEMBLY
  1. Remove the bolt and air cleaner hose assembly.



13. REMOVE COMPRESSOR OUTLET ELBOW


    A113753
  1. Remove the 2 bolts and 2 clamps, then remove the compressor outlet elbow.



14. REMOVE VENTILATION PIPE
  1. Remove the bolt and ventilation pipe.



15. DISCONNECT ENGINE WIRE
  1. Disconnect the engine wire from the bracket.



16. REMOVE WATER INLET


    A102455E01
  1. Remove the 3 bolts and water inlet.



17. REMOVE THERMOSTAT
  1. Remove thermostat and gasket.