Home › ENGINE ยท 2KD-FTV › FUEL › FUEL COOLER

FUEL COOLER > INSTALLATION

for Preparation Click here



1. INSTALL FUEL COOLER


    A103534E01
  1. Install the fuel cooler with the 3 bolts.

    Torque:
    18 N*m{ 180 kgf*cm , 13 ft.*lbf }



    A102486E01
  1. Install the 2 fuel hoses to the fuel cooler.



2. CHECK FOR FUEL LEAKS
  1. PERFORM ACTIVE TEST

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Powertrain / ECD / Active Test.

    5. Perform the Active Test.

      Intelligent Tester Display
      Test Details
      Control Range
      Diagnostic Notes
      Test the Fuel Leak
      Pressurizes common rail internal fuel pressure, and checks for fuel leaks
      Stop/Start
      1. Fuel pressure inside common rail pressurized to specified value and engine speed increased to 2,000 rpm when ON is selected
      2. Above conditions preserved while test is ON