ECD SYSTEM > ECM Power Source Circuit |

| 1.INSPECT ECM TERMINAL VOLTAGE (+B TERMINAL) |
![]() |
Turn the ignition switch ON.
Measure the voltage of the ECM connectors.
| Tester Connection | Specified Condition |
| B9-1 (+B) - D3-7 (E1) | 9 to 14 V |
|
| ||||
| NG | |
| 2.CHECK HARNESS AND CONNECTOR (ECM - BODY GROUND) |
![]() |
Disconnect the D3 ECM connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| D3-7 (E1) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK ECM TERMINAL VOLTAGE (IGSW TERMINAL) |
![]() |
Turn the ignition switch ON.
Measure the voltage of the ECM connectors.
| Tester Connection | Specified Condition |
| B9-9 (IGSW) - D3-7 (E1) | 9 to 14 V |
|
| ||||
| NG | |
| 4.INSPECT FUSE (IGN FUSE) |
![]() |
Remove the IGN fuse from the instrument panel J/B.
Measure the resistance of the fuse.
|
| ||||
| OK | |
| 5.INSPECT IGNITION SWITCH ASSEMBLY |
![]() |
Disconnect the ignition switch connector.
Measure the resistance of the ignition switch.
| Tester Connection | Switch Condition | Specified Condition |
| 5 (AM2) - 6 (IG2) | LOCK | 10 kΩ or higher |
| 5 (AM2) - 6 (IG2) | ON | Below 1 Ω |
|
| ||||
| OK | |
| 6.CHECK ECM TERMINAL VOLTAGE (MREL TERMINAL) |
![]() |
Turn the ignition switch ON.
Measure the voltage of the ECM connectors.
| Tester Connection | Specified Condition |
| B9-8 (MREL) - D3-7 (E1) | 9 to 14 V |
|
| ||||
| OK | |
| 7.INSPECT FUSE (EFI FUSE) |
![]() |
Remove the EFI fuse from the engine room J/B and K/B No.1.
Measure the resistance of the fuse.
|
| ||||
| OK | |
| 8.INSPECT INTEGRATION RELAY (MAIN RELAY) |
![]() |
Remove the integration relay from the engine room J/B and R/B No.1.
Disconnect the 1J integration relay connector.
Measure the voltage of the MAIN relay.
| Tester Connection | Condition | Specified Condition |
| 1J-4 - Body ground | Ignition switch ON | 10 to 14 V |
|
| ||||
| OK | |
| 9.CHECK HARNESS AND CONNECTOR (MAIN RELAY - ECM) |
![]() |
Disconnect the 1J integration relay connector from the engine room J/B and R/B No.1.
Disconnect the B9 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| 1J-4 - B9-1 (+B) | Below 1 Ω |
| 1J-4 or B9-1 (+B) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||