Home › ENGINE ยท 2KD-FTV › ENGINE CONTROL SYSTEM › ECD SYSTEM

ECD SYSTEM > MIL Circuit

for Preparation Click here


DESCRIPTION

If the ECM detects a malfunction, the MIL illuminates. The ECM then records the DTC in its memory.

WIRING DIAGRAM


A110965E01


INSPECTION PROCEDURE

NOTICE:
After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).

1.CHECK MIL CONDITION

HINT:
Use the table below to troubleshoot each problem symptom.


Reference: 
Condition
Proceed To
MIL remains ON
A
MIL is not illuminated
B


B
Go to step 4
A


2.CHECK IF MIL TURNS OFF
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON and turn the intelligent tester ON.

  1. Enter the following menus: Power train / ECD / DTC.

  1. Check if DTCs have been stored. Take notes if there are DTCs.

  1. Enter the following menus: Power train / ECD / DTC / Clear.

  1. Clear the DTC(s) (Click here).

  1. Check if the MIL turns OFF.

    OK:
    MIL turns OFF.



OK
GO TO DTC CHART
NG


3.CHECK HARNESS AND CONNECTOR


    A065748E08
  1. Disconnect the B9 ECM connector.

  1. Turn the engine switch ON.

  1. Check that the MIL does not illuminate.

    OK:
    MIL does not illuminate.



NG
REPLACE ECM
OK

REPAIR OR REPLACE HARNESS AND CONNECTOR 

4.CHECK IF MIL ILLUMINATES
  1. Check if the MIL illuminates when the engine switch is turned ON.

    OK:
    MIL illuminates.



OK
END
NG


5.CHECK COMBINATION METER ASSY (MIL CIRCUIT)

OK:
Combination meter circuit is normal.



NG
REPAIR OR REPLACE COMBINATION METER ASSEMBLY
OK

REPAIR OR REPLACE HARNESS AND CONNECTOR (COMBINATION METER - ECM)