ECD SYSTEM > CHECK MODE PROCEDURE |
| CHECK MODE PROCEDURE |
![]() |
Turn the ignition switch OFF.
Make sure that the vehicle is in the following conditions:
Battery voltage is 11 V or more.
Accelerator pedal released.
Release parking brake lever.
Shift lever is on N position.
A/C switch is turned OFF.
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the intelligent tester ON.
![]() |
Enter the following menus: Powertrain / ECD / Check Mode.
Make sure that the MIL flashes as shown in the illustration.
Start the engine (the MIL should turn OFF).
Simulate the conditions of the malfunction described by the customer.
Check the DTC(s) and freeze frame data using the intelligent tester.
After checking the DTC, inspect the appropriate circuits (Click here).