Home › ENGINE · 2KD-FTV › ENGINE CONTROL SYSTEM › ECD SYSTEM

DTC    P0627/78    Fuel Pump Control Circuit / Open

for Preparation Click here


DESCRIPTION

Refer to the system description (Click here).

DTC No.
DTC Detection Condition
Trouble Area
P0627/78
Open or short in suction control valve circuit for more than 0.5 seconds
(1 trip detection logic)
  1. Open or short in suction control valve circuit
  2. Suction control valve
  3. ECM

HINT:
  1. For more information on the supply pump (suction control valve) and the common rail system, refer to the system description (Click here).
  2. When DTC P0627/78 is set, check the internal fuel pressure of the common rail by entering the following menus on the intelligent tester : Powertrain / ECD / Data List / Fuel Press.


Reference:

Engine Speed
Fuel Pressure
Idling
Approximately 25 to 35 MPa
2,500 rpm (No engine load)
Approximately 35 to 55 MPa


WIRING DIAGRAM


A110961E01


INSPECTION PROCEDURE

NOTICE:
  1. After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).
  2. After replace the supply pump, the ECM needs initialization (Click here).

HINT:
Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

1.INSPECT SUPPLY PUMP ASSEMBLY (SUCTION CONTROL VALVE)


    A104093E01
  1. Disconnect the D47 suction control valve connector.

  1. Measure the resistance of the suction control valve.

    Standard resistance:
    1.9 to 2.3 Ω at 20°C (68°F)



NG
REPLACE SUPPLY PUMP ASSEMBLY
OK


2.CHECK HARNESS AND CONNECTOR


    A099839E02
  1. Disconnect the D47 valve connector.

  1. Disconnect the D1 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    D47-1 (PCV+) - D1-2 (PCV+)
    Below 1 Ω
    D47-2 (PCV-) - D1-1 (PCV-)
    Below 1 Ω
    D47-1 (PCV+) - D1-2 (PCV+) - Body ground
    10 kΩ or higher
    D47-2 (PCV-) - D1-1 (PCV-) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK ECM TERMINAL VOLTAGE (PCV TERMINAL)


    A099840E01
  1. While cranking or idling the engine, check the waveform of the ECM connector using an oscilloscope.

    Standard:
    Tester Connection
    Specified Condition
    D1-2 (PCV+) - D1-1 (PCV-)
    Correct waveform is shown
    Tool Setting
    10 V/DIV., 5 msec./DIV.
    Condition
    Idling or cranking with warm engine

    HINT:
    The waveform varies depending on the suction control valve operation.



NG
REPLACE ECM
OK

CHECK FOR INTERMITTENT PROBLEMS