PARKING BRAKE SYSTEM > ADJUSTMENT |
| 1. INSPECT PARKING BRAKE CONTROL HANDLE TRAVEL |
Pull firmly on the parking brake control handle.
Release the parking brake lock, and return the parking brake control handle to its off position.
Slowly pull the parking brake control handle all the way up, and count the number of clicks.
| 2. REMOVE REAR WHEEL |
| 3. ADJUST REAR BRAKE SHOE CLEARANCE |
| 4. INSTALL REAR WHEEL |
| 5. ADJUST PARKING BRAKE CONTROL HANDLE TRAVEL |
Lift the vehicle
![]() |
Depress the parking brake handle. Hold the parking brake adjusting nut using a wrench, and loosen the lock nut.
Turn the parking brake adjusting nut until the parking brake handle travel meets the above specification.
Count the number of clicks after depressing and releasing the parking brake control handle 3 or 4 times.
Check whether the parking brake drags or not.
When operating the parking brake control handle, check that the parking brake indicator light comes on.
Hold the parking brake adjusting nut using a wrench, and tighten the lock nut.
Lower the vehicle.