PARKING BRAKE LEVER > REASSEMBLY |
| 1. INSTALL PARKING BRAKE PLUNGER ASSEMBLY |
Apply MP grease to 2 new parking brake pawls and 2 pins.
Install the 2 parking brake pawls and springs to the parking brake plunger guide.
Install the 2 parking brake pawl pins.
![]() |
Holding one side of the parking brake pawl pin with a metal block, tap the other side with a hammer to stake it.
![]() |
Using a screwdriver, install a new parking brake bush to the parking brake plunger guide.
![]() |
Move the 2 parking brake pawls (A) to release the lock, and push in the parking brake plunger assembly (B) as shown in the illustration.
![]() |
Install a new parking brake plunger anti-rattle to the parking brake plunger assembly.
![]() |
Using a hammer, install the parking brake plunger pin in the position shown in the illustration.
| 2. INSTALL PARKING BRAKE CABLE ASSEMBLY NO.1 |
![]() |
Install the parking brake cable assembly No.1 to the bracket.
![]() |
Move the parking brake pawl (A) to release the lock, and push in the parking brake plunger assembly as shown in the illustration (B).
![]() |
Connect the parking brake cable assembly No.1 to the parking brake plunger assembly.
Install the bracket to the parking brake plunger guide.
![]() |
Apply MP grease to the parking brake wire pawl pin.
Push the parking brake wire pulley as shown in the illustration, install the parking brake wire pawl pin.
![]() |
Install the clip to the parking brake wire pawl pin.
![]() |
Install the clip.
![]() |
Install the parking brake switch.
![]() |
Install the parking brake plunger protector.