Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › STEERING PAD

STEERING PAD > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM BATTERY NEGATIVE TERMINAL

NOTICE:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.



2. REMOVE STEERING WHEEL COVER LOWER NO.2
  1. Using a screwdriver, remove the steering wheel No.2 cover lower.

    HINT:
    Tape up the screwdriver tip before use.



3. REMOVE STEERING WHEEL COVER LOWER NO.3
  1. Using a screwdriver, remove the steering wheel No.3 cover lower.

    HINT:
    Tape up the screwdriver tip before use.



4. REMOVE STEERING PAD


    C106057E01
  1. Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.

  1. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand.

  1. Disconnect the horn connector.



    C106058
  1. Disconnect the connector and remove the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.