SPIRAL CABLE > REMOVAL |
| 1. DISCONNECT CABLE FROM BATTERY NEGATIVE TERMINAL |
| 2. REPLACE FRONT WHEELS FACING STRAIGHT AHEAD |
| 3. REMOVE STEERING WHEEL COVER LOWER NO.2 |
Using a screwdriver, remove the steering wheel No.2 cover lower.
| 4. REMOVE STEERING WHEEL COVER LOWER NO.3 |
Using a screwdriver, remove the steering wheel No.3 cover lower.
| 5. REMOVE STEERING PAD |
![]() |
Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.
Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand.
Disconnect the horn connector.
![]() |
Disconnect the connector and remove the steering pad.
| 6. REMOVE STEERING WHEEL ASSEMBLY |
Remove the steering wheel set nut.
Put matchmarks on the steering wheel assembly and steering main shaft assembly.
![]() |
Using SST, remove the steering wheel assembly.
| 7. REMOVE STEERING COLUMN COVER LOWER |
Set the steering tilt mechanism to the lowermost position.
![]() |
Remove the 2 "torx" screws from the steering column cover lower.
![]() |
Press on the left side of the steering column cover lower to disengage claw A.
![]() |
Press on the right side of the steering column cover lower to disengage claw B.
| 8. REMOVE SPIRAL CABLE ASSEMBLY |
Lock the shift lever at the lowest position.
Disengage the claws and slide the steering column upper cover upward.
Disconnect the connectors from the spiral cable.
![]() |
Disengage the 3 claws and remove the spiral cable.