Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CENTER AIRBAG SENSOR ASSEMBLY

CENTER AIRBAG SENSOR ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM BATTERY NEGATIVE TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.



2. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1


    B102828
  1. Using a clip remover, remove the 2 clips

  1. Disengage the 3 claws and remove the instrument panel No.1 under cover sub-assembly.



3. REMOVE AIR BAG SENSOR ASSEMBLY CENTER


    C101571
  1. Disconnect the airbag connectors, as shown in the illustration.

  1. Remove the 3 bolts and center airbag sensor.