Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM

WIRELESS DOOR LOCK CONTROL SYSTEM > SYSTEM DESCRIPTION

for Preparation Click here



WIRELESS DOOR CONTROL SYSTEM DESCRIPTION
  1. This system locks and unlocks the vehicle's doors remotely. The wireless control system has the following functions and features:

    1. The door control receiver performs the code identification process and the body ECU operates the door lock control. A serial data link is provided for communication between the door control receiver and the body ECU.
    2. A key-integrated type transmitter is used and it has a door lock switch and door unlock switch.

  2. The wireless door lock control system has the following functions:

    Function
    Outline
    All door lock operation
    Pressing the LOCK switch locks all doors when all doors are closed.
    All door unlock operation
    Pressing the UNLOCK switch unlocks all doors.
    Automatic lock function
    If any of the doors is not opened within 30 seconds after they are unlocked by the wireless operation, all doors will lock again automatically.
    Answer back operation
    Hazard warning lights flash once when the doors are locked, and flash twice when the doors are unlocked. These flashes indicate completion of operation.
    Repeat function
    If any door is not locked in response to the locking operation by the LOCK switch, the body ECU will output a lock signal after 1 second.


OPERATION INTERLOCK FUNCTION
  1. Lock operation is not available when:

    1. Any of the doors is open.
    1. The key is in the ignition switch cylinder.

  2. Unlock operation is not available when:

    1. The key is in the ignition switch cylinder.


FUNCTION OF MAIN COMPONENTS

Components
Functions
Door control transmitter
  1. Contains the lock and unlock switches.
  2. Transmits weak electric waves (recognition codes and function codes) to the door control receiver.
  3. Illuminates the indicator light (LED) during transmission.
Door control receiver
Receives weak electric waves (recognition codes and function codes) and outputs them as code data to the body ECU.
  1. Front door courtesy light switch
  2. Rear door courtesy light switch
  3. Back door courtesy light switch
Turns on when a door is opened and off when a door is closed. Outputs door status (open or closed) to the body ECU.
Unlock warning switch
Detects whether the key is (not) inserted in the ignition switch.
Door lock position switch
Transmits the door lock positions of each door to the body ECU.
Body ECU
Transmits wireless door lock control signals in response to the code data from the door control receiver and signals from each switch.

TRANSMITTER RECOGNITION CODE REGISTRATION FUNCTION
The table below shows the 4 special coded ID registration function modes through which up to 4 different codes can be registered. The codes are electronically registered (written to and stored) in the EEPROM that is contained in the body ECU.

Mode
Function
Add mode
Adds a newly received code while preserving any previously registered codes.
The mode is used when adding a new transmitter. If the number of codes exceeds 4, the oldest registered code is erased first.
Rewrite mode
Erases all previously registered codes and registers only the newly received codes.
Confirmation mode
Confirms how many codes are currently registered. When adding a new code, this mode is used to check how many codes already exist.
Prohibition mode
Prohibits the wireless door lock function to delete all the registered codes.
This mode is used when the transmitter is lost.