WIRELESS DOOR LOCK CONTROL SYSTEM > REGISTRATION |
| 1. PROCEDURE FOR RECOGNITION CODE REGISTRATION |
The following conditions should be met before starting the procedure:
Insert the key into the ignition key cylinder, then pull it out (Procedure "A").
Insert the key into the ignition key cylinder, then pull it out within 5 seconds after procedure "A" (Procedure "B").
Close and open the driver side door twice.
Insert the key into the ignition key cylinder, then pull it out within 40 seconds after procedure "B" (Procedure "C").
Close and open the driver side door twice.
Insert the key into the ignition key cylinder and close all doors within 40 seconds after procedure "C" (Procedure "D").
Turn the ignition switch from the LOCK to the ON position and back to the LOCK position at approximately 1 second intervals according to the number of times shown in the table below.
| Mode Selection | Ignition Switch ON-LOCK Operation | Ignition Key Position |
| Add mode | Once | ![]() |
| ||
| Rewrite Mode | Twice | ![]() |
| ||
| Confirmation Mode | 3 times | ![]() |
| ||
| Prohibition Mode | 5 times | ![]() |
|
Remove the key from the ignition key cylinder within 40 seconds after the procedure "D" (Procedure "E").
The body ECU automatically performs power door LOCK-UNLOCK operations to indicate which mode has been selected.
| Mode Selection | Power Door Lock LOCK-UNLOCK | Door Lock Status |
| Add mode | 1 cycle | ![]() |
| ||
| Rewrite Mode | 2 cycles | ![]() |
| ||
| Confirmation Mode | The number of registered codes (1 to 4 cycles) | ![]() |
| ||
| Prohibition Mode | 5 cycles | ![]() |
|
| Mode Selection | Procedure |
| Add Mode | Continued on next step. |
| Rewrite Mode | |
| Confirmation Mode | Registration procedures are completed. |
| Prohibition Mode |
Press both LOCK and UNLOCK switches on the transmitter simultaneously for 1 second or more. (Procedure F)
Press either LOCK or UNLOCK switch for 1 second or more within 45 seconds after performing procedure E.
The body ECU automatically performs power door LOCK-UNLOCK operations to indicate whether registration has been completed correctly.
| Power Door Lock LOCK-UNLOCK Operation | Result | Door Lock Status |
| 1 cycle | Registration of recognition code has been completed. | ![]() |
| ||
| 2 cycles | Registration of recognition code has failed. | ![]() |
|
| Next Operation | Procedure |
| Another transmitter needs to be registered. | Return to procedure "F" within 40 seconds (*1). |
| Finish registration procedure. | Continued on next step. |
Perform either of the following:
Registration of recognition codes (add mode and rewrite mode) is completed.