Home › BRAKE › BRAKE › BRAKE MASTER CYLINDER

BRAKE MASTER CYLINDER > DISASSEMBLY

for Preparation Click here



1. REMOVE BRAKE MASTER CYLINDER KIT
  1. Place the master cylinder in the vise.



    C102758E01
  1. Using the SST, loosen the cap.

    SST
    09922-10010  

    NOTICE:
    Use the SST as illustrated.



    C102760
  1. Remove the cap from the brake master less reservoir tank cylinder sub-assembly.

    NOTICE:
    Fix the primary piston so it is not pulled out.



    C102761
  1. Using a screwdriver, remove the secondary cup from the cap.

    NOTICE:
    Do not damage the inner surface of the cap.

    HINT:
    1. Check the cup direction.
    2. Tape the screwdriver tip before use.

  1. Using the screwdriver, remove the 3 O-rings from the cap.

    NOTICE:
    Do not damage the cap.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the spacer and the primary cup from the primary piston.

    HINT:
    Check the cup direction.



    C102762
  1. Pull out the primary piston, sleeve and secondary piston together from the cylinder body.

    NOTICE:
    1. Hold the sleeve when pulling them out.
    2. Do not damage the inner surface of the cylinder body and the piston.

  1. Remove the spring.

  1. Remove the primary cup and the secondary piston from the sleeve.

    HINT:
    Check the cup direction.



    C102764
  1. Using a screwdriver, remove the pressure cup from the sleeve.

    NOTICE:
    Do not damage the sleeve.

    HINT:
    1. Check the cup direction.
    2. Tape the screwdriver tip before use.

  1. Using a screwdriver, remove the O-ring from the sleeve.

    NOTICE:
    Do not damage the sleeve.

    HINT:
    Tape the screwdriver tip before use.