Home › BRAKE › BRAKE › BRAKE MASTER CYLINDER

BRAKE MASTER CYLINDER > REASSEMBLY

for Preparation Click here



1. INSTALL BRAKE MASTER CYLINDER KIT
  1. Apply lithium soap base glycol grease to the 2 primary cups, pressure cup and O-ring.

  1. Install the pressure cup and O-ring to the sleeve.

    NOTICE:
    Check direction and size of the cup.

  1. Install the primary cup and the spring to the secondary piston.

    NOTICE:
    Check direction and size of the cup.

  1. Install the primary cup, secondary piston and spring together to the sleeve.



    C102765E01
  1. Install the primary cup and the spacer to the primary piston.

    NOTICE:
    Check the cup direction.



    C102762
  1. Install the spring, secondary piston, sleeve and primary piston together to the cylinder body.

    NOTICE:
    1. Hold the sleeve when installing them.
    2. Check that the sleeve is installed all the way to the end of the cylinder body.



    C102766E01
  1. Apply lithium soap base glycol grease to the 3 secondary cups and the 3 O-rings.

  1. Install the secondary cups and the 3 O-rings to the cap.

    NOTICE:
    Check direction and size of the cup.

  1. Temporarily install the cap to the cylinder body by hand.

  1. Place the master cylinder in the vise.



    C102759E01
  1. Using the SST, fully tighten the cap.

    SST
    09922-10010  

    Torque:
    11.8 N*m{ 120 kgf*cm , 9 ft.*lbf }

    NOTICE:
    Use the SST as illustrated.