Home › BRAKE › BRAKE › 5L VACUUM PUMP

5L VACUUM PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL OIL SEAL


    F000817E01
  1. Using SST and a hummer, tap in the oil seal.

    SST
    09950-60010   (09951-00400)
    09950-70010   (09951-07150)



2. INSTALL O-RING
  1. Apply the engine oil on a new O-ring and install the O-ring to the vacuum pump case.



3. INSTALL VACUUM PUMP BEARING


    F043198
  1. Using a press, install a new bearing to the pump shaft.



4. INSTALL VACUUM PUMP SHAFT
  1. Install the vacuum pump shaft and stop ring to the vacuum pump case.



5. INSTALL VACUUM PUMP BLADE A


    F043199
  1. Apply the engine oil on a rotor and the 5 new vacuum pump blades.

  1. Install the rotor and the pump blades with the round end facing outward.



    F043221
  1. Install the end plate with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 17 in.*lbf }



6. INSTALL VACUUM PUMP END COVER


    F000813
  1. Install the end cover with the 4 screws.

    Torque:
    4.6 N*m{ 47 kgf*cm , 41 in.*lbf }



7. INSTALL BRAKE VACUUM CHECK VALVE ASSEMBLY


    F043197
  1. Using soft jaws, place vacuum pump in a vise, install a new gasket, and check valve.

    Torque:
    74 N*m{ 750 kgf*cm , 54 ft.*lbf }



8. INSTALL VACUUM PUMP VACUUM HOSE UNION


    F043220E01
  1. Using SST, hold the check valve assembly, and install vacuum hose union with union bolt and 2 new gaskets.

    SST
    09922-10010  

    Torque:
    14 N*m{ 140 kgf*cm , 10 ft.*lbf }



9. INSTALL VACUUM PUMP PULLEY


    C106117
  1. Install the vacuum pump pulley and pulley lock nut.

    Torque:
    105 N*m{ 1,075 kgf*cm , 78 ft.*lbf }