Home › BRAKE › BRAKE › 2KD-FTV VACUUM PUMP

2KD-FTV VACUUM PUMP > INSTALLATION

for Preparation Click here



1. INSTALL VACUUM PUMP ASSEMBLY
  1. Apply the engine oil to the 2 new O-rings.

  1. Install the 2 O-rings to the vacuum pump assembly.



    C102555
  1. Install the vacuum pump assembly to the engine with the 2 nuts.

    Torque:
    21 N*m{ 210 kgf*cm , 15 ft.*lbf }

    NOTICE:
    1. Do not drop the vacuum pump packing.
    2. Make sure that the vacuum pump assembly is securely installed.



    C102554
  1. Install the vacuum pump union and the 2 new gaskets with the union bolt.

    Torque:
    14 N*m{ 140 kgf*cm , 10 ft.*lbf }

    NOTICE:
    Check that the stopper of the vacuum pump union is securely holding on the vacuum pump assembly.

  1. Connect the 2 hoses with the clip to the vacuum pump.

    NOTICE:
    Set the vacuum hose so the white marking facing upward.



2. INSPECT VACUUM PUMP ASSEMBLY
  1. Disconnect the vacuum hose.

  1. Connect the vacuum gauge to the vacuum pump.

  1. Start the engine.



    C095557E02
  1. Measure the vacuum with the engine idling.

    Standard:
    More than 650 mmHg (86.7 kPa).



3. INSTALL ENGINE UNDER COVER SUB-ASSEMBLY NO.2


4. INSTALL ENGINE UNDER COVER NO.1