Home › BRAKE › BRAKE › 2KD-FTV VACUUM PUMP

2KD-FTV VACUUM PUMP > DISASSEMBLY

for Preparation Click here



1. REMOVE CHECK VALVE ASSEMBLY


    C061437
  1. Remove the check valve assembly and gasket.



2. REMOVE VACUUM PUMP BLADE A


    C061438
  1. Remove the 3 bolts.



    C095657
  1. Place the vacuum pump in a vise as shown in the illustration.

    CAUTION:
    Do not tighten the vise too much.

  1. Using a pin punch (φ5 mm) and hammer, drive out the 2 straight pins.

  1. Remove the end cover and 2 O-rings.



    F005377
  1. Remove the vacuum pump rotor sub-assembly with 5 blades.



3. REMOVE VACUUM PUMP GEAR
  1. Using soft jaws, clamp the gear in the vise.

    NOTICE:
    Do not tighten the vise too much.



    C095668
  1. Remove the gear lock nut.

  1. Remove the vacuum pump gear and woodruff key.



4. REMOVE VACUUM PUMP SHAFT


    C061441
  1. Using a plastic hammer, tap out the vacuum pump shaft.



    C060750E01
  1. Using snap ring pliers, remove the snap ring.



    C061863
  1. Using a press and a 17mm socket wrench, press out the ball bearing.