2KD-FTV VACUUM PUMP > REASSEMBLY |
| 1. INSTALL VACUUM PUMP SHAFT |
![]() |
Using a press, install the new ball bearing to the vacuum pump shaft.
![]() |
Using SST and a press, install the vacuum pump shaft to the housing.
![]() |
Using a snap ring pliers, install the snap ring.
| 2. INSTALL VACUUM PUMP ROTOR ASSEMBLY |
Apply the engine oil to the rotor, and install the rotor in the vacuum pump shaft.
| 3. INSTALL VACUUM PUMP BLADE A |
![]() |
Apply the engine oil to the 5 vacuum pump blades.
Install the 5 vacuum pump blades into the vacuum pump housing.
| 4. INSTALL VACUUM PUMP END COVER |
![]() |
Place the vacuum pump in a vise, as shown in the illustration.
Apply the engine oil to the 2 O-rings.
Install the 2 new O-rings and the vacuum pump end cover temporarily with the 3 bolts.
Using a pin punch (φ5 mm) and hammer, drive in the 2 straight pins.
![]() |
Fully tighten the 3 bolts.
| 5. INSTALL CHECK VALVE ASSEMBLY |
Install a new gasket and the check valve.
| 6. INSTALL VACUUM PUMP GEAR |
Temporarily install the woodruff key, vacuum pump gear and gear lock nut to the pump shaft.
Using soft jaws, clamp the vacuum pump gear in the vise.
Tighten the gear lock nut.
| 7. INSPECT VACUUM PUMP ASSEMBLY |
![]() |
Turn the gear in the vacuum pump counter-clockwise (left-hand turn, viewed from the gear side) and check for improper movement or torque change.