Home › BRAKE › BRAKE › REAR BRAKE

REAR BRAKE > INSPECTION

for Preparation Click here



1. INSPECT BRAKE DRUM INSIDE DIAMETER


    F006408
  1. Using a brake drum gauge or equivalent, measure the inside diameter of the drum.

    Standard inside diameter:
    256 mm (10.079 in.)
    Maximum inside diameter:
    254 mm (10.000 in.)

    HINT:
    If the inside diameter of the brake drum is more than the maximum, replace the brake drum.



2. INSPECT BRAKE SHOES LINING THICKNESS


    F042690
  1. Using a ruler, measure the thickness of the shoe lining.

    Standard thickness:
    5.1 mm (0.201 in.)
    Minimum thickness:
    1.0 mm (0.039 in.)

    HINT:
    If the lining thickness is less than the minimum thickness, or if there is severe, uneven wear, replace the brake shoe.



3. INSPECT BRAKE DRUM AND BRAKE SHOE LINING FOR PROPER CONTACT


    R001564
  1. Apply chalk to the inside surface of the drum, then grind drum on the brake shoe lining to fit.

    HINT:
    If the contact between the drum and the shoe lining is improper, repair it using a brake shoe grinder or replace the brake shoe assembly.



4. INSPECT BRAKE WHEEL CYLINDER
  1. Check the cylinder bore and the piston for rust or scoring.

    HINT:
    If necessary, replace the wheel brake cylinder assembly.