Home › BRAKE › BRAKE › REAR BRAKE

REAR BRAKE > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. DRAIN BRAKE FLUID


3. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY


    C102597E01
  1. Release the parking brake lever, and remove the brake drum.

    HINT:
    If the brake drum cannot be removed easily, perform the following steps.

  1. Remove the hole plug and insert a screwdriver through the hole in the backing plate, and hold the automatic adjusting lever away from the adjuster.

  1. Using another screwdriver, contract the brake shoe adjuster by turning the adjusting wheel.



4. REMOVE REAR AXLE BRAKE DRUM GASKET


5. REMOVE AUTOMATIC ADJUST LEVER


    C102605
  1. Remove the automatic adjust lever and the tension spring.



6. SEPARATE PARKING BRAKE SHOE STRUT SET


    C102599E01
  1. Using SST, remove the upper side tension spring from the brake shoe.

    SST
    09703-30011  



7. REMOVE FRONT BRAKE SHOE


    C102600
  1. Using a needle-nose pliers, remove the anchor side tension spring.



    C102601E01
  1. Using SST, remove the cup, shoe hold-down sprig and pin.

    SST
    09718-00010  



    C102667
  1. Remove the parking brake shoe lower strut.

  1. Separate the brake shoe return spring, and remove the front brake shoe.



8. REMOVE REAR BRAKE SHOE


    C102603E01
  1. Using SST, remove the cup, shoe hold-down sprig and pin.

    SST
    09718-00010  



    C102606
  1. Disconnect the parking brake cable No.3 and remove the rear brake shoe.



9. REMOVE PARKING BRAKE SHOE STRUT SET


    C102607E01
  1. Using a screwdriver, remove the C-washer, brake shoe lever, rear cushion lever and brake shoe strut set from the brake shoe.

  1. Remove the adjusting bolt and tension spring from the brake shoe strut set.



10. REMOVE REAR WHEEL BRAKE CYLINDER ASSEMBLY


    C102608
  1. Using SST, disconnect the brake tube, use a container to catch brake fluid.

    SST
    09023-00101  

  1. Remove the 2 bolts and wheel cylinder.



11. REMOVE REAR WHEEL BRAKE CYLINDER CUP KIT
  1. Remove the 2 cylinder dust boots from the wheel cylinder.

  1. Remove the 2 pistons.

  1. Remove the 2 cylinder cups from each piston.

  1. Remove the compression spring.



12. REMOVE REAR DRUM BRAKE BLEEDER PLUG