BRAKE ACTUATOR > REMOVAL |
| 1. DRAIN BRAKE FLUID |
| 2. DRAIN ENGINE COOLANT |
| 3. REMOVE FRONT WHEEL |
| 4. REMOVE ENGINE UNDER COVER NO.1 |
| 5. REMOVE RADIATOR GRILLE |
![]() |
Remove the 2 clips and 2 screws.
Release the 6 claws and 4 clips and remove the radiator grille.
| 6. REMOVE RADIATOR SUPPORT SEAL UPPER (LHD (W/O INTERCOOLER ASSEMBLY)) |
![]() |
Remove the 6 clips and radiator support seal upper.
| 7. REMOVE AIR INLET DUCT NO.1 (LHD (W/ INTERCOOLER ASSEMBLY)) |
![]() |
Remove the 3 clips and the air inlet duct No.2.
Remove the 2 bolts, 2 clips and the air inlet duct No.1.
| 8. REMOVE AIR INLET DUCT NO.2 (LHD (W/ INTERCOOLER ASSEMBLY)) |
| 9. REMOVE STEP PLATE COVER LH |
![]() |
Remove the 4 clips.
Release the claw and remove the step plate cover.
| 10. REMOVE STEP PLATE COVER RH |
| 11. REMOVE FRONT BUMPER |
![]() |
Remove the 8 clips and 3 bolts.
Release the 12 claws and remove the bumper.
Disconnect the connectors. (w/ fog light)
| 12. REMOVE HOOD LOCK SUPPORT BRACE SUB-ASSEMBLY |
| 13. REMOVE FRONT BUMPER REINFORCEMENT |
![]() |
Remove the 6 bolts and front bumper reinforcement.
| 14. REMOVE HOOD LOCK ASSEMBLY |
![]() |
Remove the 3 bolts, hood lock control cable and the hood lock assembly.
| 15. REMOVE RADIATOR SUPPORT UPPER |
![]() |
Remove the 6 bolts, 2 screws and the radiator upper support.
| 16. REMOVE RADIATOR RESERVE TANK ASSEMBLY |
![]() |
Remove the bolt, and separate the radiator reserve tank assembly from the body panel.
Remove the clip, and disconnect the water by-pass hose No.1.
Remove the clip, and disconnect the water by-pass hose No.2.
Remove the radiator reserve tank assembly.
| 17. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY |
![]() |
Remove the 2 bolts.
Separate the hose and connector, and remove the windshield washer jar assembly.
| 18. REMOVE HIGH PITCHED HORN ASSEMBLY |
| 19. REMOVE SUB RADIATOR ASSEMBLY |
| 20. REMOVE FRONT MUDGUARD |
![]() |
Remove the 3 clips and the front mudguard.
| 21. REMOVE BRAKE ACTUATOR ASSEMBLY WITH FRONT BRAKE TUBE WAY NO.1 |
![]() |
Release the lock lever and disconnect the actuator connector.
![]() |
Using SST, disconnect the 6 brake tubes from the brake tube way No.1.
![]() |
Remove the 5 bolts. Remove the brake actuator assembly together with the front brake tube way No.1 and brake tube.
| 22. REMOVE BRAKE TUBE |
![]() |
Using SST, remove the 5 brake tubes and the brake tube way No.1.
| 23. REMOVE ACTUATOR BOLT COVER |
![]() |
Remove the 2 nuts and the actuator cover.
| 24. REMOVE BRAKE ACTUATOR ASSEMBLY |
![]() |
Remove the the 2 nuts and brake actuator assembly from the brake actuator bracket.