Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING UNIT

AIR CONDITIONING UNIT > DISASSEMBLY

for Preparation Click here



1. REMOVE MODE CONTROL CABLE


    E103878E01
  1. Using a screwdriver wrapped with protective tape, release the claw and remove the mode control cable.



2. REMOVE AIR MIX CONTROL CABLE


    E103879E01
  1. Using a screwdriver wrapped with protective tape, release the claw and remove the air mix control cable.



3. REMOVE INSTRUMENT PANEL REGS CONNECTOR ASSEMBLY CENTER


    E103877E01
  1. Release the 4 claws and remove the instrument panel regs connector assembly center.



4. REMOVE QUICK HEATER ASSEMBLY (w/ PTC)


    E103880
  1. Remove the 2 screws and quick heater assembly.



5. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY


    E103881
  1. Remove the screw and heater radiator unit sub-assembly.



6. REMOVE AIR DUCT NO.3


    E103882E02
  1. Remove the 2 screws.

  1. Release the 2 claws and remove the air duct No.3.



7. REMOVE DRAIN COOLER HOSE


    E107301
  1. Remove the drain cooler hose.



8. REMOVE HEATER BRACKET


    E107302
  1. Remove the screw and heater bracket.



9. REMOVE COOLER EXPANSION VALVE


    E107303
  1. Using a hexagon wrench 4 mm, remove the 2 hexagon bolts and cooler expansion valve.



10. REMOVE COOLER EVAPORATOR SUB-ASSEMBLY NO.1


    E107720E02
  1. Remove the 4 screws.

  1. Release the 2 claws and remove the heater case lower.



    E103887E01
  1. Release the clamp and remove the cooler evaporator sub-assembly.



11. REMOVE EVAPORATOR TEMPERATURE SENSOR


    E110828E01
  1. Remove the evaporator temperature sensor.