Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING UNIT

AIR CONDITIONING UNIT > REASSEMBLY

for Preparation Click here



1. INSTALL EVAPORATOR TEMPERATURE SENSOR


    E107306E01
  1. Install the sensor to the evaporator as shown in the illustration.

  1. Check that the sensor sticks to the evaporator surface as shown in the illustration (A: Sensor, B: Evaporator).

    NOTICE:
    If reusing the evaporator, do not insert the sensor to the position that it had been inserted before. Insert it between position C shown in the illustration.



2. INSTALL COOLER EVAPORATOR SUB-ASSEMBLY NO.1
  1. Sufficiently apply compressor oil (ND-OIL 8) to 2 new O-rings and the fitting surface. Install the 2 O-rings to the cooler evaporator No.1.

    Compressor oil:
    ND-OIL 8 or equivalent

  1. Install the cooler evaporator sub-assembly.



    E103887E01
  1. Install the connector.



    E107720E02
  1. Install the heater case lower with the 2 claws and 4 screws.



3. INSTALL COOLER EXPANSION VALVE


    E107303
  1. Using a hexagon wrench 4 mm, install the cooler expansion valve with the 2 hexagon bolts.

    Torque:
    3.5 N*m{ 35 kgf*cm , 30 in.*lbf }



4. INSTALL HEATER BRACKET


    E107302
  1. Install the heater bracket with the bolt.



5. INSTALL DRAIN COOLER HOSE


    E107301
  1. Install the drain cooler hose.



6. INSTALL AIR DUCT NO.3


    E103882E02
  1. Engage the 2 claws to install the air duct No.3.

  1. Install the 2 screws.



7. INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY


    E103881
  1. Install the heater radiator unit sub-assembly with the screw.



8. INSTALL QUICK HEATER ASSEMBLY (w/ PTC)


    E103880
  1. Install the quick heater assembly with the 2 screws.



9. INSTALL INSTRUMENT PANEL REGS CONNECTOR ASSEMBLY CENTER


    E103877E01
  1. Engage the 4 claws to install instrument panel regs connector assembly.



10. INSTALL AIR MIX CONTROL CABLE


    E104594E01
  1. Fully turn the air mix control cable gear and unit gear in the direction indicated by the arrows to set them at "MAX. COOL".

  1. Install the air mix control cable.



11. INSTALL MODE CONTROL CABLE


    E104593E01
  1. Fully turn the air mode control cable gear and unit link in the direction indicated by the arrows to set them at "FACE".

  1. Install the mode control cable.