Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › 2KD-FTV COMPRESSOR AND MAGNETIC CLUTCH

2KD-FTV COMPRESSOR AND MAGNETIC CLUTCH > DISASSEMBLY

for Preparation Click here



1. REMOVE MAGNETIC CLUTCH ASSEMBLY
  1. Place the compressor and magnetic clutch in a vise.



    E066614E01
  1. Using SST, hold the magnet clutch hub.

    SST
    95047-10400  

  1. Remove the bolt, magnet clutch hub and the magnet clutch washer.

    HINT:
    There is no set number of magnet clutch washer since they are used for adjusting.



    E108882
  1. Using a snap ring expander, remove the snap ring and magnet clutch rotor.

    NOTICE:
    Take care not to damage the seal cover of the bearing when removing the snap ring.

  1. Disconnect the connector.



    E108883
  1. Using a snap ring expander, remove the snap ring and magnet clutch starter.