Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › 2KD-FTV COMPRESSOR AND MAGNETIC CLUTCH

2KD-FTV COMPRESSOR AND MAGNETIC CLUTCH > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT W/PULLY COMPRESSOR ASSEMBLY


    E034870E02
  1. Disconnect the connector from the w/ pulley compressor assembly.

  1. Connect the positive (+) lead from the battery to terminal 3 and the negative (-) lead to the body ground.

  1. Check that the magnetic clutch energized.

    OK:
    The magnetic clutch energized.

  1. Measure the resistance between terminal 1 and 2.

    Standard resistance:
    165 to 205 Ω at 20 °C (68 °F)

    If the resistance value is not as specified, replace the w/ pulley compressor assembly.