5L-E COMPRESSOR AND MAGNETIC CLUTCH > INSTALLATION |
| 1. INSTALL COMPRESSOR AND MAGNETIC CLUTCH |
![]() |
Install the compressor and magnetic clutch with the 4 bolts.
| 2. INSTALL COOLER REFRIGERANT SUCTION HOSE NO.1 |
Remove the attached vinyl tape from the hose.
Apply sufficient compressor oil (ND-OIL 8) to a new O-ring and the fitting surface of the compressor and magnetic clutch.
Install the O-ring onto the cooler refrigerant suction hose No.1.
![]() |
Install the cooler refrigerant suction hose No.1 onto the compressor and magnetic clutch with the bolt.
| 3. INSTALL COOLER REFRIGERANT DISCHARGE HOSE NO.1 |
![]() |
Remove the attached vinyl tape from the hose.
Apply sufficient compressor oil (ND-OIL 8) to a new O-ring and the fitting surface of the compressor and magnetic clutch.
Install the O-ring onto the cooler refrigerant discharge hose No.1.
Install the cooler refrigerant discharge hose No.1 onto the compressor and magnetic clutch with the bolt.
| 4. INSTALL V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1 |
![]() |
Install the V belt as shown in the illustration.
| 5. ADJUST V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1 |
![]() |
Tightening the bolt , adjust the tension of the V belt.
Apply drive belt tension by turning bolt.
Drive belt deflection
Drive belt tension
Apply drive belt tension by turning bolt.
![]() |
Tighten nut.
| 6. INSTALL ENGINE UNDER COVER NO.1 |
| 7. INSTALL ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY |
Install the 5 bolts and engine service hole cover.
| 8. REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type) |
Perform the same procedure as above on the opposite side.
| 9. INSTALL FRONT SEAT ASSEMBLY RH (for Low-back Seat Type) |
Perform the same procedure as above on the opposite side.
| 10. INSTALL FRONT DOOR SCUFF PLATE RH |
| 11. CHARGE REFRIGERANT |
Perform vacuum purging using a vacuum pump.
Charge with refrigerant HFC-134a (R134a).

| 12. WARM UP ENGINE |
Warm up the engine at less than 1,850 rpm for 2 minutes or more after charging refrigerant.
| 13. CHECK FOR LEAKAGE OF REFRIGERANT |
After recharging refrigerant gas, check for leakage of refrigerant gas using a halogen leak detector.
Carry out the test under the following conditions:
![]() |
Using a gas leak detector, check for leakage of the refrigerant line.
![]() |
Bring the gas leak detector close to the drain hose with the detector's power off.
If a gas leak is not detected on the drain hose, remove the blower motor control from the cooling unit. Insert the gas leak detector sensor into the unit and perform the test.
Disconnect the pressure switch connector and leave it for approximately 20 minutes. Bring the gas leak detector close to the pressure switch and perform the test.