5L-E COMPRESSOR AND MAGNETIC CLUTCH > REASSEMBLY |
| 1. INSTALL MAGNETIC CLUTCH ASSEMBLY |
Please the compressor and magnetic clutch in a vise.
![]() |
Install the magnet clutch starter with the parts shown in the illustration matched.
![]() |
Using a snap ring expander, install a new snap ring with the chamfered side facing up.
Connect the connector.
![]() |
Using a snap ring expander, install the magnet clutch rotor and a new snap ring with the chamfered side facing up.
Install the magnet clutch washer and magnet clutch hub.
![]() |
Using SST, install the magnet clutch hub and the magnet clutch washer with the bolt.
| 2. INSPECT MAGNETIC CLUTCH CLEARANCE |
![]() |
Set the dial indicator to the magnet clutch hub.
Connect the battery positive lead to terminal 3 of the magnet clutch connector and the negative lead to the ground wire. Turn the magnet clutch on and off and measure the clearance.
| 3. ADJUST COMPRESSOR OIL |
When replacing the compressor and magnetic clutch with a new one, gradually discharge the refrigerant gas from the service valve, and drain the following amount of oil from the new compressor and magnetic clutch before installation.