Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > DISPOSAL

for Preparation Click here



1. DISPOSE OF FRONT SHOCK ABSORBER


    C103217E02
  1. With the piston rod extended, hold the front shock absorber obliquely in a vise.

  1. Using a saw or cutting tools, slowly make a hole at approximately 20 mm (0.79 in.) from the weld in the lower end of the front shock absorber to discharge the gas inside.

    NOTICE:
    1. The gas is colorless, odorless and harmless.
    2. Cover the saw or cutting tools with a shop rug or a piece of cloth to prevent shards of metal from flying about when discharging the gas.