Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > INSTALLATION

for Preparation Click here



1. TEMPORARILY TIGHTEN FRONT SHOCK ABSORBER


    C103228
  1. Install front shock absorber No.1 cushion retainer, front shock absorber No.2 cushion retainer, and the front shock absorber cushion to the front shock absorber.

    NOTICE:
    Install the cushion retainers in the correct direction.

  1. Install the front shock absorber, front shock absorber No.1 cushion retainer , front shock absorber No.2 cushion retainer, and the front shock absorber cushion to the vehicle, and temporarily tighten a new lock nut.

    NOTICE:
    Install the cushion retainers in the correct direction.



    C113860
  1. Hold the width across flat of the piston rod and tighten the lock nut with an adjustable wrench until the protrusion length of the thread is the standard length.

    Standard:
    3 +- 1 mm (0.12 +- 0.04 in.)



    C101181E01
  1. Install the front shock absorber to the front suspension lower arm. Insert the bolt from the front side of the vehicle and temporarily tighten the bolt.



2. INSTALL FRONT WHEEL

Torque:
100 N*m{ 1020 kgf*cm , 74 ft.*lbf }



3. STABILIZE SUSPENSION
  1. Bounce the vehicle up and down several times to stabilize suspension.



4. FULLY TIGHTEN FRONT SHOCK ABSORBER


    C101181E01
  1. Tighten the bolt on the lower side of the front shock absorber.

    Torque:
    105 N*m{ 1,070 kgf*cm , 77 ft.*lbf }